[quote=AN]What wheel bearing? I don’t remember changing the wheel bearing when changing the pads and rotor.[/quote]
Honda rotors if I recall are pressed onto the axle.
Then again they might have changed this on later years.
Apparently this was the case for
90 honda’s. I don’t recall what was the case for my first generation integra..
In any case, honda was notorious for sticking a phillips screw to hold the rotor in place that I recall was almost impossible to remove… I recall I inevitably ended up drilling them out a few times…
I hated doing rotors on the hondas my buddy had or I had.
Here’s a refresher… If you didn’t have to deal with this, you were lucky..
But I have to say, at least for hondas it doesn’t require you to drop have a fuel tank to replace a fuel filter like *cough* a B5 Audi A4…. (I lucked out because I have small hands)…
Surprising the Mercedes w203 C class isn’t that bad to work on…. I pretty much replaced the front end recently…
